Cisco: 877W Configure Wireless and Wired on Single Subnet

  This article will demonstrate how to configure a cisco router to allow the wireless and wired networks to communicate on the same vlan and subnet.

IOS version: 12.4(15)T12
Router Model: Cisco 877W
Router Series: Cisco 880 Series Integrated Services Routers

1. Configure DHCP Pool
2. Configure the SSID
3. Configure Vlan 1 Interface
4. Configure Dot11Radio Interface
5. Configure the Bridge Interface

Hot adding or removing a Cisco 3750 from a stack

When using a Cisco 3750 stack connected through stackwise technology you can add or remove a Cisco switch while the stack stays on. If you are adding or removing a switch from the stack, it is very important that the switch is turned OFF. The rest of the stack can keep doing its business.

Activate IPv6 at Cisco Switch

over Lan Base grade switch

SNMP commands

Cisco Switch SSH commands

Cisco Switch SSH commands

Cisco IP Phone Recovery using TFTPd32 (without CUCM)

If you are in network permitting only static IP address,

Converting Cisco Lightweight to standalone

When converting LWAP to standalone, there is a easy way.

HP Procurve Networking Advanced CLI Command Reference

This page will provide a subset of advanced HP Procurve Networking CLI commands for easy reference.

HP Procurve Networking Initial Setup

HP Procurve Networking Configuration will be done via the CLI and assumes you have a console connection to the switch and are in configure mode. Enter configure mode by typeing configure.

unknown protocol drops (Cisco)

unknown protocol drops reporta os pacotes com protocolo desconhecido ou não configurado por interface.

Configurar CBWFQ (Class-Based Weighted Fair Queueing) nos Cisco

Class-based weighted fair queueing (CBWFQ) fornece suporte para a personalização de classes de tráfego. Para CBWFQ, definimos as classes de tráfego baseado em critérios que podem incluir

configurar AP em standalone

Quando um Access Point opera em conjunto com o WLC dizemos que o mesmo é Lightweight. Já quando não há um WLC, dizemos que o AP é Standalone.

reverse telnet

Reverse Telnet gives you the ability to telnet to a device, and then console to another device from there.